A fault code doesn’t yet mean the unit or sensor itself is faulty: often it’s the plug and connector leading to it.
OOleg’s tip: it’s not always the sensor
It may not be the sensor itself but what it reads the signal from: the tone ring on the hub or axle shaft, or, on many cars, a magnetic ring that is built into the wheel bearing itself. Dirt, rust, a crack or damaged teeth, or bearing play — and there’s no signal even though the sensor is fine.
Remove the sensor and, turning the wheel slowly, look at the tone ring: are all the teeth intact and clean? Rock the wheel by hand — bearing play also disrupts the signal. The magnetic ring isn’t replaced separately: it’s part of the bearing.
Possible causes
- Open wire or poor contact in the connector
- The sensor wire is chafed or broken — in the wheel arch, by the shock absorber or at the bend near the hub
- This wheel’s speed sensor
- The ABS control unit (less often)
What you can do yourself
- With this fault ABS usually switches off: the ordinary brakes still work, but without ABS the wheels can lock. Brake smoothly and leave a bigger gap, especially on slippery roads.
- Inspect this wheel’s sensor and its wire up to the connector: dirt, corroded pins, chafed insulation. Clean the connector, remove the sensor and clean its tip and its seat of dirt and rust.
- Check the tone ring or the bearing’s magnetic ring: cracks, damaged teeth, stuck-on metal shavings. Don’t clean a magnetic ring with a magnet.
- A scan tool’s live data shows each wheel’s speed: while driving, this wheel should read the same as the others.
Stop and don’t drive on if:
- The red brake light is on, or the brake pedal feels soft or sinks
- The steering became very heavy, or the car pulls to one side when braking
OOleg’s tip: check the connector
Often the cause is simple — there is no contact in the connector (plug). Look at the connector from the back: remove the rubber seal and you will see whether a wire is corroded or has come off completely. Corrosion shows up as green deposits. Ideally, gently pull each wire towards you one at a time: a sound wire stays in place, while a corroded one simply comes off — it needs to be repaired.
Unplug and inspect connectors with the ignition off.
The explanation comes from the error code reference in the AvtoElektrik PRO app.