A fault code doesn’t yet mean the unit or sensor itself is faulty: often it’s the plug and connector leading to it.
Possible causes
- Faulty or misadjusted brake pedal switch
- Open circuit, short or corrosion in the wiring and connector
- Blown fuse or brake light bulbs
- Rarely — the control unit
What you can do yourself
- Check whether the brake lights come on when the pedal is pressed
- Check the brake light fuse and bulbs
- Check the switch connector and adjustment
- Driving without brake lights is dangerous — repair right away
Stop and don’t drive on if:
- The Check Engine light is flashing
- The temperature gauge is in the red or the overheating light is on
- The red oil pressure light is on
- Smoke from under the bonnet, a burning or petrol smell
- Strong jerking, knocking from the engine, or the car barely moves
OOleg’s tip: check the connector
Often the cause is simple — there is no contact in the connector (plug). Look at the connector from the back: remove the rubber seal and you will see whether a wire is corroded or has come off completely. Corrosion shows up as green deposits. Ideally, gently pull each wire towards you one at a time: a sound wire stays in place, while a corroded one simply comes off — it needs to be repaired.
Unplug and inspect connectors with the ignition off.
Find the part on Kaspi ShopBefore buying, check the part number or match the part by VIN in the Kaspi “Garage”.
On Oleg’s website:Transmission adaptation ↗
The explanation comes from the error code reference in the AvtoElektrik PRO app.