A fault code doesn’t yet mean the unit or sensor itself is faulty: often it’s the plug and connector leading to it.
Possible causes
- Cracked booster vacuum hose
- The sensor itself
- Sensor connector or wiring: corrosion, an open circuit, a chafed wire
What you can do yourself
- The sensor is on the brake booster or its hose. Check the connector and the hose.
- If the brake pedal has become hard with the engine running, check the booster vacuum hose and go to a mechanic straight away.
Stop and don’t drive on if:
- The Check Engine light is flashing
- The temperature gauge is in the red or the overheating light is on
- The red oil pressure light is on
- Smoke from under the bonnet, a burning or petrol smell
- Strong jerking, knocking from the engine, or the car barely moves
OOleg’s tip: check the connector
Often the cause is simple — there is no contact in the connector (plug). Look at the connector from the back: remove the rubber seal and you will see whether a wire is corroded or has come off completely. Corrosion shows up as green deposits. Ideally, gently pull each wire towards you one at a time: a sound wire stays in place, while a corroded one simply comes off — it needs to be repaired.
Unplug and inspect connectors with the ignition off.
Find the part on Kaspi ShopBefore buying, check the part number or match the part by VIN in the Kaspi “Garage”.
The explanation comes from the error code reference in the AvtoElektrik PRO app.